Preparation of high-activity coal char-based catalysts from high metals containing coal gangue and lignite for catalytic decomposition of biomass tar

The potential of using high metals containing coal gangue and lignite to prepare high-activity coal char-based catalysts is investigated for effective biomass tar decomposition. Loose structure and rough surface are formed for these char-based catalysts with heterogeneous distribution of a large number of inorganic particles. In the biomass tar decomposition, the performance of the coal char-based catalysts is significantly influenced by the content of the metals in the raw materials and coal gangue char (GC) with the ash content as high as 50.80% exhibits the highest activity in this work. A high biomass tar conversion efficiency of 93.5% is achieved at 800 °C along with a significant increase in the fuel gas product. During the five-time consecutive tests, the catalytic performance of GC increases a little at the second or third times reuse and remains relatively stable, showing the remarkable stability of the catalyst in biomass tar decomposition applications.     

Preparation and characterization of mullite whisker reinforced ceramics made from coal fly ash

Ceramics with mullite whiskers were prepared from coal fly ash and Al₂O₃ raw materials, with AlF₃ used as an additive. The phase structures and microstructures of the ceramics were identified via X-ray diffraction and scanning electron microscopy, respectively. The results show that pickling of coal fly ash is an effective method for enhancing the flexural strength of ceramics. Sintering temperature and AlF₃ addition were also key factors influencing the creation of ideal ceramics. The ceramic made from pickled coal fly ash, 6?wt% AlF₃, and sintered at 1200?°C, exhibited the highest flexural strength of 59.1?MPa, and had a bulk density of 1.32?g/cm³ and porosity of 26.8%. The results show that ceramic materials made under these conditions are ideal candidates for manufacturing ceramic proppants for the exploitation of unconventional oil and gas resources.     

Flame characteristics of premixed H2-air mixtures explosion venting in a spherical container through a duct

The explosion venting duct can effectively reduce the hazard degree of a gas explosion and conduct the venting energy to the safe area. To investigate the flame quantitative propagation law of explosion venting with a duct, the effects of hydrogen fraction and explosion venting duct length on jet flame propagation characteristics of premixed H₂-air mixtures were analyzed through experiment and simulation. The experiment results under initial conditions of room temperature and 1 atm show that when hydrogen fraction was high enough, part of the unburned hydrogen was mixed with air again to reach an ignitable concentration, resulting in the secondary combustion was easier produced and the duration of the secondary flame increased. With the increase of venting duct length, the flame front distance and propagation velocity increased. Meanwhile, the spatial distribution of pressure field and temperature field, and the propagation process and mechanism of the flame venting with a duct were analyzed using FLUENT software. The variation of the pressure wave and the pressure reflection oscillation law in the explosion venting duct was captured. Therefore, in the industrial explosion venting design with a duct, the hazard caused by the coupling of venting pressure and venting flame under different fractions should be considered comprehensively.     

湾图沟煤矿高强度采动巷道稳定性评价研究

针对高强度采动巷道围岩控制难题，从实验室岩样尺度和现场巷道尺度研究了湾图沟煤矿13405工作面回风平巷围岩稳定性特征。结合单轴压缩试验和声波测试分析了干燥、自然及饱和状态下3组岩样的力学行为差异特征。利用钻孔成像，分析了高强度采动影响巷道围岩裂隙发育分段特征。结果表明:干燥、自然及饱和状态下岩样的单轴抗压强度和弹性模量依次降低，水分的存在极大地降低了岩石的强度和刚度。实煤体段围岩仅在深度1 m范围内发现少量纵向裂隙。高静压段两帮维护效果较差，煤帮裂隙极为发育，存在高量值的离层。动压段巷道顶板完整性较好，两帮均发现较大离层，且超出了锚杆正常锚固范围，严重影响了巷道锚固结构的稳定性。     

高温旋风除尘器的设计

在PTA(精对苯二甲酸)的生产过程中,工艺废气经尾气膨胀透平机降压后进入RTO蓄热式焚烧炉将有毒有害的有机物焚烧分解后排入大气,为了达到粉尘的排放标准(小于120mg/m~3),在焚烧炉之后加上这台高温烟气除尘器,废气经除尘后达到了排放标准,而且最大程度地减少了热量损失,实践证明此项改造是成功的。文章探讨如何进行高温烟气除尘器的设计,并介绍了高温多管陶瓷旋风烟气除尘器的结构。     

一起罕见的粗氩充装爆炸事故

对一起粗氩 充装设备发生爆炸事故进行了现场介绍、原因分析，找出了导致事故的主因，并提出了防范措施．     

һ����ӱ����˹����ȼ����ȼ�Զ���Ͽ���װ��

我国是煤资源大国，长期来在采煤的同时，抽放排空大量煤层瓦斯，不仅浪费大量资源，还严重污染大气。利用煤层瓦斯发电是解决煤层瓦斯放空的重要途径 。文章介绍一种全新的有别于传统 发动机的瓦斯内燃机空燃自动混合控制装置，其中包括：煤层瓦斯的理化特性、装置的结构、工作原理及工作过程，阐述了结构参数对发动机性能的影响。经过在中心瓦斯工区内燃发动机组群上安装试运行，结果表明：该装置可以适用于高、中、低不同浓度的煤层瓦斯，性能稳定、可靠，达到了设计性能指标，完全满足燃气,内燃机组的使用要求，并取得了很好的经济效益、生态效益和环保效益。     

������Ȼ����̽���о����½�չ����չ����

2002年AAPG年会于3月10－13日在美国休斯顿隆重召开。根据会议论文，介绍了国外天然气勘探与研究最新进展及发展趋势，其中包括：生物气、海域及深水区有利含气区带、际上新老气区带等常规天然气，以及煤层气、深盆气、天然气水合物等非常规天然气的最新勘探与研究进展。     

Synthesis, Characterization, and Formation Process of Na-X Zeolite from Coal Fly Ash

Using the SiO₂ and Al₂O₃ components of the amorphous phase in coal fly ash (Fa), Fa was converted to Na-X zeolites in NaOH-NaAlO₂ solutions by stirring at 35°C for 72 hr and then aging at 85°C for a given period. The molar ratio SiO₂/Al₂O₃ of the starting materials was controlled from 2.0 to 13.2. The resulting materials were characterized by various means. Increasing the SiO₂/Al₂O₃ ratio of the starting material increased the degree of crystallinity of faujasite, exhibiting a maximum at SiO₂/Al₂O₃ = 8.0. The faujasite formed was identified as Na-X zeolite with Si/Al = 1.20. The amorphous phase in Fa was dissolved during the stirring to form a precursor of zeolite, such as amorphous aluminosilicate. The Na-X zeolite was formed by aging for 24 hr, and the degree of crystallinity of this material was increased with the increasing aging period. The cation exchange capacity and specific surface area were increased with the increasing degree of crystallinity of the Na-X zeolites.